<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: Cluster Status

To view the status of your PRTG installation, select Setup | PRTG Status from the main menu bar. Select the various tabs to change the different settings.

PRTG Status Tabs

PRTG Status Tabs

You can view the following aspects of the PRTG status:

Cluster Status

i_round_blueThis tab is only available if you run PRTG in a cluster.

Click the Cluster Status tab to view all cluster nodes. The following information is available:

  • Cluster Status: Shows all connected cluster nodes as table and graphic
  • Cluster Log: Shows all log entries for cluster connections
Cluster Status Tab

Cluster Status Tab

Click the Start Maintenance Mode link to put a cluster node in maintenance mode. A cluster node in this mode is still connected to the cluster, but its monitoring results are discarded until you click the Stop Maintenance Mode link. You can use this functionality to explicitly exclude a cluster node from monitoring if you know that the monitoring values are not accurate, for example, because you are reconfiguring the server. During maintenance, a cluster node is displayed with a transparent color in the overview graphic.

i_round_blueOn the Cluster Status tab, you do not see if your remote probes are connected to failover nodes. Connect to your failover nodes and explicitly check if remote probes are connected (for example, in the device tree of the PRTG web interface on a cluster node).

i_square_cyanFor more information about cluster settings, see section Cluster.

i_podThis feature is not available in PRTG Hosted Monitor.



There are some settings that you must make in the PRTG Administration Tool. For more details, see the sections: